How to do Placement and Layout Planning on Microsoft-Paint.Īfter the completion of this course you can design any "Mixed Signal with Micro-Controller available across the world". ![]() Power Distribution Network Analysis (PDN Analysis) of any PCB.įerrite Bead, ESD Diodes, and Magnetic Application and their selection. How to do Pin-mapping using Cube-MX tool. How to Create a RIGID-FLEX PCB and its Stack-up Layer Stack-up Selection and Rules for Defining any Stack-upĭifferent Grounding Techniques( Signal Grounding, Earth Grounding, Chassis Grounding) Pre-Schematic Design Blocks (Block Diagram and Power Budget) ![]() ![]() You will also learn some Basic Blocks as well: Various Subparts as you can see from the Curriculum. ![]() Major Schematic Blocks that I have designed in this course are "Ethernet PHY 10/100 Mb/s", "I2S DAC for Headphone and Speaker", "MEMS MIC", "24BIT ADC", "36W Bi-Directional Brushed DC Motor Divers", "UART to USB TTL Converter", "STM32F103 Controller as Debugger and Programmer", "STM32F407 Main Controller", "Power Supply and Protections" and many more. I have Divided this course into 4 Major Sections:ġst Section is Selection of Each Components whatever Going inside the Schematic.Ģnd Section is Schematic Designing by Reading Datasheets.ģrd Stack-up 4L/6L/8L/12L, Components Placement Planning and Execution.Ĥth Inter Block and Intra Block Layout Planning and Execution.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |